How do I fix zebra printer feeds too far between labels?

Usually a size or calibration mismatch. Set the artboard to the real roll, calibrate the printer, then send one test from the free browser app.

Do I need ZebraDesigner or a paid license?

No. Design in the browser and print with Zebra Browser Print, or export PNG, PDF, or ZPL. No desktop designer seat.

Should I reprint the whole roll while testing?

No. Print quantity 1 until the label looks right, then run the rest.

Zebra printer feeds too far between labels

Published: August 17, 2026 · 3 min read · Problem

Do this in the free app: app.mylabelmaker.com. No signup. Design the label, then print on a Zebra or download PNG / PDF / ZPL.

A long extra feed means the printer’s stored length is longer than the stock, or it never saw a gap. Set length to the real label, calibrate, print one. Open the free label maker to do it now.

Good to know: Continuous (no-gap) stock with gap-sense on will hunt and feed a lot of paper. Match mode to media.

How to fix it

Open the free label maker. No signup.
Set the label size to the exact width and length of the roll in the printer.
Calibrate the gap or black-mark sensor if you just changed stock.
Print one test label. Do not send a whole stack until it looks right.

Wasted 4×6

Seller groups complain about wasting a label every job. Fix length once; do not keep reprinting to “use up” the extra.

Print or save

After the test looks right, print the rest from the same design. Save a JSON copy so you can open it again later.

Fix it in the free app

Set the size, print one test label, no account.

Open free label maker