How do I fix zebra printer keeps pausing?

Usually a size or calibration mismatch. Set the artboard to the real roll, calibrate the printer, then send one test from the free browser app.

Do I need ZebraDesigner or a paid license?

No. Design in the browser and print with Zebra Browser Print, or export PNG, PDF, or ZPL. No desktop designer seat.

Should I reprint the whole roll while testing?

No. Print quantity 1 until the label looks right, then run the rest.

Zebra printer keeps pausing

Published: August 17, 2026 · 3 min read · Problem

Do this in the free app: app.mylabelmaker.com. No signup. Design the label, then print on a Zebra or download PNG / PDF / ZPL.

A printer that pauses after every label is often in peel/liner-takeup mode, or someone tapped Pause. Take it out of peel if you are tearing, press Pause to resume, send one job. Open the free label maker to do it now.

Good to know: A failing take-up motor in peel mode will pause forever. That is hardware, not the designer.

How to fix it

Open the free label maker. No signup.
Set the label size to the exact width and length of the roll in the printer.
Calibrate the gap or black-mark sensor if you just changed stock.
Print one test label. Do not send a whole stack until it looks right.

Browser Print status

The app can surface “Printer paused.” Clear the printer, then send again. Do not queue 40 jobs while it is paused.

Print or save

After the test looks right, print the rest from the same design. Save a JSON copy so you can open it again later.

Fix it in the free app

Set the size, print one test label, no account.

Open free label maker